Hitachi Compute Blade 500 Series User Manual page 337

Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Error: Could not find loader image in Management Module,
error code:[0xXXXX].
XXXX:EFI Status Code
There is no LPAR manager loader image file in management
module.
Check whether LPAR manager firmware is installed in
management module. If there is no problem in installation,
contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Error: Could not find network controller, error code:
XXXX:EFI Status Code
Detection of NIC for communication failed.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Error: Could not get ip address from BMC, error code:
XXXX:EFI Status Code
Acquisition of IP Address from BMC failed.
Check whether the IP address is set correctly in the LPAR
manager setting screen on Web console. When it is not correct,
set the correct IP address. If this message appears in spite of
correct settings, contact the reseller from which you purchased
this equipment or consult maintenance personnel.
Error: Could not get loader image size from Management
Module, error code:[0xXXXX].
Please check network connection with management
module and network
XXXX:EFI Status Code
Acquisition of the image size of a LPAR manager loader failed.
Check there are not any problems in a setup of a network, a LAN
switch and a connection.
If it is satisfactory after a check, Contact the reseller from which
you purchased this equipment or consult maintenance personnel.
Error: Could not load loader image from Management
Module, error code:[0xXXXX].
Please check network connection with management
module and network
XXXX:EFI Status Code
Reading the LPAR manager loader failed.
Messages
[0xXXXX].
[0xXXXX].
9-3