Hitachi Compute Blade 500 Series User Manual page 442

HvmGetPerf Command
The HvmGetPerf command obtains an overview of system operation from the
specified LPAR manager and outputs the results to the specified destination.
It can also output information for a specific LPAR only.
If it cannot connect to the specified LPAR manager, it terminates by time-out.
Execute the HvmGetPerf command as follows: (Δ indicates a space.)
HvmGetPerfΔ-host=Ip-address[Δ-type=item-to-be-obtained] [Δ-lpar=LPAR-number] [Δ-
filename=output-destination-file-name] [Δ-timeout=timeout-time] [Δ-srcip=IP-address]
The table below describes options for HvmGetPerf command.
-host=IP-address
-type=item-to-be-obtained
-lpar=LPAR-number
-filename=output-
destination-file-name
-timeout=timeou-ttime
-srcip=IP-address
F-2
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Table F-1 Options for HvmGetPerf command
Option
Specify the IP address of the LPAR manager for which to
obtain an overview of operation. Specify an address in
dot-delimited decimal format ("."). This parameter is
required.
Example: 192.168.0.20
Specify the item for which to obtain an overview of
operation. The following values can be specified.
all Obtains all operation overview items.
host Obtains an operation overview for the LPAR manager
system.
pcpu Obtains an operation overview for the physical CPU.
lpar Obtains an operation overview for the LPAR.
If this option is omitted, the command obtains all
operation overview items.
Specify the LPAR number for which to obtain an overview
of operation using an integer. If this option is omitted, the
command outputs information for all LPARs.
The command outputs an overview of operation in text
format to the specified file. If the specified file exists, the
contents of the file are erased and overwritten with the
operation outline information. If a minus sign (-) is
specified as the destination, the command outputs an
overview of operation to the standard output. If the -
filename parameter is omitted, the command outputs
operation overview information in summary format to the
standard output.
Specify the time in which the command times out if it
cannot connect to the LPAR manager, in the range from 1
to 3600 seconds. If this option is omitted, the command
will time out in three seconds. If 0 is specified, the
HvmGetPerf command never times out and infinitely waits
for a response from the LPAR manager.
Specify an IP address on the management server side for
communicating LP IP Address of the sender. This setting is
HvmGetPerf Command
Description