Hitachi Compute Blade 500 Series User Manual page 229

Figure 7-7 Virtual Console Allocation Screen
How to change the Pre-boot firmware
[For CB 520H B3 / CB 520X B1/B2:]
The Pre-boot firmware only can be changed while deactivating LPAR.
Place the cursor on the PB column of the LPAR line, and press Enter. The
sub-screen is displayed. Select 64UEFI/BIOS, and press Enter.
How to change the guest NUMA setting
[LPAR manager firmware version 02-0X or later]
You can change the guest NUMA setting only for deactivated LPARs.
The following table shows whether the guest NUMA setting can be configured.
NUMA for the Guest NUMA for
EFI LPAR manager
Enabled
Enabled
Enabled
Disabled
The guest NUMA is enabled or disabled for each LPAR.
Use the [F11] and [F12] keys to scroll the page to the left and right. Place
the cursor on the NUMA column of the LPAR row, and press [Enter]. The sub-
screen is displayed. Select Yes or No, and press [Enter].
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
LPAR status
Supported
Supported
Not supported
--
Guest NUMA setting
for the LPAR
Deactivated
Activated
--
--
Possible
Not possible
Not possible
Not possible
7-25