Hitachi Compute Blade 500 Series User Manual page 105

Item
LPAR manager Partition information
Config File
Logical Server Information
LPAR manager Status
(Activate Information of
LPAR)
IP Address of NTP server
vfcWWN (HBA WWN on the
LPAR manager)
MAC Address of Logical NIC
(VNIC System No.)
LPAR manager LPAR manager firmware
Firmware
Bank No. on which LPAR
Information
manager firmware is
installed
LPAR manager firmware
version
LP License LPAR manager License
Information
(Essential/Advanced
License)
Upper-limit of upgradable/
updatable LPAR manager
Firmware version
VLAN Information VLAN Information for
connected LAN Switch port
Notes:
1 Values for the items are exchanged between the active and the standby server blade
.
when any values are set for the items of not only the active but also the standby
server blade
2 When switching under N+M cold standby environment, the items are transferred to
.
a standby server blade and the items of the active server blade are cleared.
3 When the same LPAR manager firmware version is installed on the active and the
.
standby server blade, the LPAR manager firmware version is assigned. However,
when the different LPAR manager firmware versions are installed on the active and
the standby server blade, the upper version or revision of LPAR manager firmware
installed on the standby server blade is assigned.
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Description
High Reliability Functions
Attention for N+M cold
Transfer standby configuration
environment
Yes
Yes
Yes
Yes
1
Yes
Yes
No It is necessary to install
the LPAR manager
No
firmware for assigning
the LPAR manager
firmware to the
management module of
3
Yes
standby server blade.
No It is necessary to set
beforehand to a standby
server blade the
information written to
left-hand side.
No
Yes [LAN Switch]
Communication with
Cm2/NC is necessary for
transferring the
information.
[DCB Switch]
Uses the AMPP function
in DCB Switch.
3-5