Hitachi Compute Blade 500 Series User Manual page 316

No.
(8)
(9)
(10)
7-112
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Item
If the Service Percentage calculated inside
LPAR manager does not match the
specified Service Ratio, "*" is displayed on
the right side. If it does match, "*" is not
displayed.
Grp (ALL): "---" is displayed
Displays "---" when the LPAR is in the
dedicated mode.
Srv(ms) Displays the total service time of the LPAR
in milliseconds.
If the LPAR is in the dedicated mode, this
value is obtained by the following formula.
Srv(ms) = the number of physical
processors running properly on the LPAR x
1000ms
If the LPAR is in the shared mode, this
value is obtained by the following formula.
Srv(ms) = the number of shared physical
processors running properly x Srv(%) of
the LPAR x 1000ms
If the LPAR is in the shared mode and
Srv(%) is displayed with "*", "*" will be
also displayed in the right side of this field.
Dsp(ms) Displays the execution time of the LPAR in
milliseconds.
This value is the total execution time of the
logical processors on the LPAR.
Busy(%) Displays the busy ratio of the LPAR. This
value is the proportion of execution time to
the LPAR's service time, and is obtained by
the following formula.
Busy (%) = the LPAR's Dsp(ms) ÷ the
LPAR's Srv (ms) x 100
The value of this field is used as the
yardstick for resource changes. If this
value exceeds 100%, it means that the
LPAR has insufficient resources.
If Processor Capping becomes enabled, the
LPAR Busy ratio is controlled so as not to
exceed 100%. Therefore this value cannot
be used as a yardstick for changing
resources anymore.
(Note)
Even if the processor capping function is
on, the LPAR manager allocation rate
Operation by LPAR manager Screen
Description
Supported
Default LPAR
Value manager
Version
--- 01-0X~
--- 01-0X~
--- 01-0X~