Lpar Manager Boot Messages - Hitachi Compute Blade 500 Series User Manual

LPAR manager Boot Messages

Followings are the LPAR manager messages that appear at LPAR manager
boot.
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
Message Content
Explanation
What to do
9-2
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
4-SMP with this blade is unsupported. So, the LP can't boot.
Reconfigure the server partition.
4-SMP with this blade is unsupported. So, the LPAR manager boot
is suppressed.
Set the supported SMP configuration, and boot the LPAR
manager.
Capacity on demand is unsupported.
Capacity on demand is not supported.
Do not use the LP mode.
Connection to SVP is tried again. retryCount=X,
statusCode=0xXXXX
XXXX:EFI Status code
The LPAR manager loader retried a failed attempt to connect to
SVP.
No action is required because the connection is established as a
result of the retry operation.
If this LP system log is collected each time LPAR manager starts,
contact the reseller from which you purchased this equipment, or
consult maintenance personnel.
Error: Could not allocate memory, error code:[0xXXXX].
XXXX:Memory Allocate Error Code
Allocating memory failed.
Confirm whether memory is recognized correctly on the Web
console. When the memory is not recognized correctly or this
message appears in spite of the correct recognition, contact the
reseller from which you purchased this equipment or consult
maintenance personnel.
Error: Could not find IPMI Device Information (Type38) in
SMBIOS, error code:[0xXXXX].
XXXX:EFI Status Code
There is no IPMI table at SMBIOS.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Messages