Hitachi Compute Blade 500 Series User Manual page 425

item
Processor
Group
Number(Grp)
Service
rate(Srv)
Memory
Size(Mem)
Memory Node
number (MN)
Idle Detection
(ID)
Automatic
Activate(AA)
Automatic
Clear(AC)
Processor
Capping(PC)
Virtual COM
Console(VC)
Pre-boot
firmware(PB)
Guest NUMA
(NUMA)
LPAR manager Logical
Screen Processor
Assignment
Logical
Processor
Configuration
LPAR manager Processor
Screen Group
Configuration
Physical
Processor
Configuration
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Setting items Description
Sets a processor group number.
Sets a Service ratio of physical
processor.
It is possible to set to only the LPAR of
Shared mode.
Sets a memory size.
Sets the Memory Node number which is
assigned to the LPAR.
MN is available only when using NUMA.
Sets "Y" when an Idle state of Logical
processor is detected.
Sets "Y" to a LPAR of Dedicated mode.
Sets the order which is a LPAR
Activated automatically when LPAR
manager-Booting.
Sets Y when carrying out the automatic
clearance of the logical SEL.
Setting 'Y' when doing a processor-
capping. It is possible to set to only
LPARs of Shared mode.
Setting "Y" when using a virtual Com
console.
For CB 520H A1/B1/B2 / CB 520A A1 /
CB 540A A1/B1:
Select pre-boot firmware.
For CB 520H B3 / CB 520X B1/B2:
Select pre-boot firmware.
Sets Y to use the guest NUMA.
It is possible to set this setting when
the NUMA setting is enabled for the EFI.
Sets an assignment of a physical
processor to a logical processor.
Sets a Processor group number
Setting Item List
Support
default
Version
0 01-0X
or later
100 01-0X
or later
1024 01-0X
or later
A 01-2X
or later
Y 01-0X
or later
*(non-assign) 01-0X
or later
N 01-0X
or later
*(non-assign) 01-0X
or later
N 01-0X
or later
BIOS 01-0X
or later
64UEFI 01-8X
or later
N 02-0X or
later
A 01-0X
or later
0 01-0X
or later
B-5