Commands In This Section - Dell N1100-ON Reference Manual

In order to reduce flapping of configuration information, if the configuration
source port is disabled, disconnected or loses LLDP connectivity, the system
clears the selection of configuration source port (if not manually selected)
and enables the willing bit on all auto-upstream ports. The configuration on
the auto-configuration ports is not cleared (configuration holdover). If the
user wishes to clear the configuration on the system in this scenario, the user
can put the configuration source port into manual mode.
When a new port is selected as configuration source, it is marked as the
configuration source, the DCBX configuration is refreshed on all auto-
configuration ports and each port may begin configuration negotiation with
their peer again (if any information has changed).

Commands in this Section

This section explains the following commands:
Data Center Bridging Capability Exchange Commands
datacenter-bridging
lldp dcbx version
lldp tlv-select dcbxp (dcb enable)
Enhanced Transmission Selection Commands
classofservice traffic-class-group
traffic-class-group max-bandwidth
traffic-class-group min-bandwidth
traffic-class-group strict
Data Center Bridging Capability Exchange
Commands
datacenter-bridging
Use the datacenter-bridging command for an Ethernet interface in order to
enter the DataCenterBridging mode. Priority-Flow-Control is configurable
from within the DataCenterBridging mode.
lldp dcbx port-role
show lldp tlv-select
show lldp dcbx
traffic-class-group weight
show classofservice traffic-class-group
show interfaces traffic
show interfaces traffic-class-group
Data Center Technology Commands
1138