General Commands; Dot1X Default; Dot1X Eapol-Pass-Through - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| Authentication Commands

802.1X Port Authentication

General Commands

dot1x eapol-

pass-through

Table 85: 802.1X Port Authentication Commands (Continued)

dot1x timeout start-period

Information Display Commands

This command sets all configurable dot1x global and port settings to their

default values.

Global Configuration

Console(config)#dot1x default

Console(config)#

This command passes EAPOL frames through to all ports in STP forwarding

state when dot1x is globally disabled. Use the no form to restore the

[no] dot1x eapol-pass-through

Discards all EAPOL frames when dot1x is globally disabled

Global Configuration

When this device is functioning as intermediate node in the network

and does not need to perform dot1x authentication, the dot1x eapol

pass-through command can be used to forward EAPOL frames from

other switches on to the authentication servers, thereby allowing the

authentication process to still be carried out by switches located on the

edge of the network.

When this device is functioning as an edge switch but does not require

any attached clients to be authenticated, the no dot1x eapol-pass-

through command can be used to discard unnecessary EAPOL traffic.

Sets the time that a supplicant port waits before

resending an EAPOL start frame to the authenticator

Shows all dot1x related information

Table of Contents