Snmp-Server View - Edge-Core ECS4810-12M Layer 2 Management Manual

◆
◆
E
This command adds an SNMP view which controls user access to the MIB.

snmp-server view

Use the no form to remove an SNMP view.
S
D
defaultview (includes access to the entire MIB tree)
C
Global Configuration
C
◆
◆
Before you configure a remote user, use the
command to specify the engine ID for the remote device where the
user resides. Then use the snmp-server user command to specify the
user and the IP address for the remote device where the user resides.
The remote agent's SNMP engine ID is used to compute authentication/
privacy digests from the user's password. If the remote engine ID is not
first configured, the snmp-server user command specifying a remote
user will fail.
SNMP passwords are localized using the engine ID of the authoritative
agent. For informs, the authoritative SNMP agent is the remote agent.
You therefore need to configure the remote agent's SNMP engine ID
before you can send proxy requests or informs to it.
XAMPLE
Console(config)#snmp-server user steve group r&d v3 auth md5 greenpeace priv
des56 einstien
Console(config)#snmp-server user mark group r&d remote 192.168.1.19 v3 auth
md5 greenpeace priv des56 einstien
Console(config)#
YNTAX
snmp-server view view-name oid-tree {included | excluded}
no snmp-server view view-name
view-name - Name of an SNMP view. (Range: 1-32 characters)
oid-tree - Object identifier of a branch within the MIB tree. Wild
cards can be used to mask a specific portion of the OID string.
(Refer to the examples.)
included - Defines an included view.
excluded - Defines an excluded view.
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
Views are used in the
access to specified portions of the MIB tree.
The predefined view "defaultview" includes access to the entire MIB
tree.
– 777 –
C
HAPTER
snmp-server engine-id
snmp-server group command to restrict user
| SNMP Commands
21
SNMPv3 Commands