Snmpv3 Commands; Snmp-Server Engine-Id - Edge-Core ECS4810-12M Layer 2 Management Manual

SNMPv3 Commands

snmp-server
engine-id
The switch can send SNMP Version 1, 2c or 3 notifications to a host IP
◆
address, depending on the SNMP version that the management station
supports. If the snmp-server host command does not specify the
SNMP version, the default is to send SNMP version 1 notifications.
If you specify an SNMP Version 3 host, then the community string is
◆
interpreted as an SNMP user name. The user name must first be
defined with the snmp-server user
group will be automatically created by the snmp-server host
command using the name of the specified community string, and
default settings for the read, write, and notify view.
E
XAMPLE
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
R C
ELATED OMMANDS
snmp-server enable traps (770)
This command configures an identification string for the SNMPv3 engine.
Use the no form to restore the default.
S
YNTAX
snmp-server engine-id {local | remote {ip-address}}
engineid-string
no snmp-server engine-id {local | remote {ip-address}}
local - Specifies the SNMP engine on this switch.
remote - Specifies an SNMP engine on a remote device.
ip-address - The IPv4 or IPv6 address of the remote device.
engineid-string - String identifying the engine ID. (Range: 1-26
hexadecimal characters)
D S
EFAULT ETTING
A unique engine ID is automatically generated by the switch based on its
MAC address.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
An SNMP engine is an independent SNMP agent that resides either on
◆
this switch or on a remote device. This engine protects against
message replay, delay, and redirection. The engine ID is also used in
combination with user passwords to generate the security keys for
authenticating and encrypting SNMPv3 packets.
– 773 –
| SNMP Commands
C 21
HAPTER
SNMPv3 Commands
command. Otherwise, an SNMPv3