Rate-Limit - Edge-Core ECS4810-12M Layer 2 Management Manual

| Congestion Control Commands
C 30
HAPTER
Rate Limit Commands

rate-limit

This command defines the rate limit for a specific interface. Use this
command without specifying a rate to enable rate limiting. Use the no form
to disable rate limiting.
S
YNTAX
rate-limit {input | output} [rate]
no rate-limit {input | output}
input – Input rate for specified interface
output – Output rate for specified interface
rate – Maximum value in Kbps.
(Range: 64-1000000 Kbps for Gigabit Ethernet ports)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
Using both rate limiting and storm control on the same interface may lead
to unexpected results. It is therefore not advisable to use both of these
commands on the same interface.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 64
Console(config-if)#
R C
ELATED OMMAND
show interfaces switchport (966)
– 1004 –