Mvr - Edge-Core ECS4810-12M Layer 2 Management Manual

Table 163: Multicast VLAN Registration for IPv4 Commands (Continued)
Command
mvr immediate-leave
mvr type
mvr vlan group
clear mrv groups dynamic
clear mrv statistics
show mvr
show mvr
associated-profile
show mvr interface
show mvr members
show mvr profile
show mvr statistics
This command enables Multicast VLAN Registration (MVR) globally on the

mvr

switch. Use the no form of this command to globally disable MVR.
S
YNTAX
[no] mvr
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages.
If MVR must be configured for an IGMP version 1 host, the multicast
groups must be statically assigned using the
E
XAMPLE
The following example enables MVR globally.
Console(config)#mvr
Console(config)#
C 39
HAPTER
Function
Enables immediate leave capability
Configures an interface as an MVR receiver or source
port
Statically binds a multicast group to a port
Clears multicast group information dynamically
learned through MVR
Clears MRV statistics
Shows information about MVR domain settings,
including MVR operational status, the multicast VLAN,
the current number of group addresses, and the
upstream source IP address
Shows the profiles bound the specified domain
Shows MVR settings for interfaces attached to the MVR
VLAN
Shows information about the current number of
entries in the forwarding database, or detailed
information about a specific multicast address
Shows all configured MVR profiles
Shows MVR protocol statistics for the specified
interface
– 1233 –
| Multicast Filtering Commands
MVR for IPv4
Mode
IC
IC
IC
PE
PE
PE
PE
PE
PE
PE
PE
mvr vlan group command.