Network-Access Max-Mac-Count - Edge-Core ECS4810-12M Layer 2 Management Manual

| General Security Measures
C 25
HAPTER
Network Access (MAC Address Authentication)
network-access
max-mac-count
trap - Issue SNMP trap message only.
trap-and-shutdown - Issue SNMP trap message and disable
the port.
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection link-up-down action trap
Console(config-if)#
Use this command to set the maximum number of MAC addresses that can
be authenticated on a port interface via all forms of authentication. Use the
no form of this command to restore the default.
S
YNTAX
network-access max-mac-count count
no network-access max-mac-count
count - The maximum number of authenticated IEEE 802.1X and
MAC addresses allowed. (Range: 0-2048; 0 for unlimited)
D S
EFAULT ETTING
1024
C M
OMMAND ODE
Interface Configuration
C U
OMMAND SAGE
The maximum number of MAC addresses per port is 1024, and the
maximum number of secure MAC addresses supported for the switch
system is 1024. When the limit is reached, all new MAC addresses are
treated as authentication failures.
E
XAMPLE
Console(config-if)#network-access max-mac-count 5
Console(config-if)#
– 876 –