Switchport Native Vlan - Edge-Core ECS4810-12M Layer 2 Management Manual

C
OMMAND
Access mode is mutually exclusive with VLAN trunking (see the
trunking
interface cannot be set to access mode, and vice versa.
E
XAMPLE
The following shows how to set the configuration mode to port 1, and then
set the switchport mode to hybrid:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode hybrid
Console(config-if)#
R C
ELATED
switchport acceptable-frame-types (1108)
This command configures the PVID (i.e., default VLAN ID) for a port. Use
switchport
the no form to restore the default.
native vlan
S
YNTAX
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4093)
D S
EFAULT
VLAN 1
C
OMMAND
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
When using Access mode, and an interface is assigned to a new VLAN,
◆
its PVID is automatically set to the identifier for that VLAN. When using
Hybrid mode, the PVID for an interface can be set to any VLAN for
which it is an untagged member.
If acceptable frame types is set to all or switchport mode is set to
◆
hybrid, the PVID will be inserted into all untagged frames entering the
ingress port.
E
XAMPLE
The following example shows how to set the PVID for port 1 to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
U
SAGE
command). If VLAN trunking is enabled on an interface, then that
OMMANDS
ETTING
M
ODE
U
SAGE
– 1111 –
| VLAN Commands
C 36
HAPTER
Configuring VLAN Interfaces
vlan-