Table of Contents
Advertisement
| Security Measures
C
13
HAPTER
Access Control Lists
C
ONFIGURING AN
E
IP
6 ACL
XTENDED
V
Figure 198: Configuring a Standard IPv6 ACL
Use the Security > ACL (Configure ACL - Add Rule - IPv6 Extended) page
to configure an Extended IPv6 ACL.
CLI R
EFERENCES
"permit, deny (Extended IPv6 ACL)" on page 934
◆
◆
"show ipv6 access-list" on page 937
"Time Range" on page 745
◆
P
ARAMETERS
These parameters are displayed:
Type – Selects the type of ACLs to show in the Name list.
◆
◆
Name – Shows the names of ACLs matching the selected type.
Action – An ACL can contain any combination of rules which permit or
◆
deny a packet.
Source Address Type – Specifies the source IP address type. Use
◆
"Any" to include all possible addresses, "Host" to specify a specific host
address in the Address field, or "IPv6-Prefix" to specify a range of
addresses. (Options: Any, Host, IPv6-Prefix; Default: Any)
Destination Address Type – Specifies the destination IP address
◆
type. Use "Any" to include all possible addresses, or "IPv6-Prefix" to
specify a range of addresses. (Options: Any, IPv6-Prefix; Default: Any)
Source/Destination IPv6 Address – An IPv6 address or network
◆
class. The address must be formatted according to RFC 2373 "IPv6
Addressing Architecture," using 8 colon-separated 16-bit hexadecimal
values. One double colon may be used in the address to indicate the
appropriate number of zeros required to fill the undefined fields.
– 368 –
Advertisement
Chapters
Table of Contents
