Transceiver-Threshold Tx-Power - Edge-Core ECS4810-12M Layer 2 Management Manual

transceiver-
threshold tx-power
C M
OMMAND ODE
Interface Configuration (SFP Ports)
C U
OMMAND SAGE
Refer to the Command Usage section under the
◆
current command for more information on configuring transceiver
thresholds.
Trap messages enabled by the
◆
to any management station configured by the
command.
E
XAMPLE
The following example sets alarm thresholds for the transceiver
temperature at port 1.
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold temperature low-alarm 97
Console(config-if)#transceiver-threshold temperature high-alarm -83
Console#
This command sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an alarm or warning
message. Use the no form to restore the default settings.
S
YNTAX
transceiver-threshold tx-power {high-alarm | high-warning |
low-alarm | low-warning} threshold-value
no transceiver-threshold tx-power
high-alarm – Sets the high power threshold for an alarm message.
high-warning – Sets the high power threshold for a warning
message.
low-alarm – Sets the low power threshold for an alarm message.
low-warning – Sets the low power threshold for a warning
message.
threshold-value – The power threshold of the transmitted signal.
(Range: -9999 - 9999 in units of 0.01 dBm)
D S
EFAULT ETTING
High Alarm: -9.00 dBm
HIgh Warning: -9.50 dBm
Low Warning: -21.00 dBm
Low Alarm: -21.50 dBm
C M
OMMAND ODE
Interface Configuration (SFP Ports)
– 971 –
| Interface Commands
C 27
HAPTER
Transceiver Threshold Configuration
transceiver-threshold
transceiver-monitor command are sent
snmp-server host