Rspan Mirroring Commands; Table 117: Rspan Commands - Edge-Core ECS4810-12M Layer 2 Management Manual

| Port Mirroring Commands
C 29
HAPTER

RSPAN Mirroring Commands

RSPAN M
IRRORING
C U
OMMAND SAGE
This command displays the currently configured source port, destination
port, and mirror mode (i.e., RX, TX, RX/TX).
E
XAMPLE
The following shows mirroring configured from port 6 to port 5:
Console(config)#interface ethernet 1/5
Console(config-if)#port monitor ethernet 1/6
Console(config-if)#end
Console#show port monitor
Port Mirroring
-------------------------------------
Destination Port (listen port):Eth1/5
Source Port (monitored port)
Mode
Console#
C
OMMANDS
Remote Switched Port Analyzer (RSPAN) allows you to mirror traffic from
remote switches for analysis on a local destination port.

Table 117: RSPAN Commands

Command Function
vlan rspan Creates a VLAN dedicated to carrying RSPAN
traffic
rspan source Specifies the source port and traffic type to be
mirrored
rspan destination Specifies the destination port to monitor the
mirrored traffic
rspan remote vlan Specifies the RSPAN VLAN, switch role (source,
intermediate or destination), and the uplink
ports
no rspan session Deletes a configured RSPAN session
show rspan Displays the configuration settings for an RSPAN
session
Configuration Guidelines
Take the following steps to configure an RSPAN session:
Use the vlan rspan
1.
(Default VLAN 1 and switch cluster VLAN 4093 are prohibited.)
Use the rspan source
2.
type (RX, TX or both) to be monitored.
Use the rspan destination
3.
the traffic mirrored by an RSPAN session.
– 996 –
:Eth1/6
:RX/TX
command to configure a VLAN to use for RSPAN.
command to specify the interfaces and the traffic
command to specify the destination port for
Mode
VC
GC
GC
GC
GC
PE