Ipv6 Mld Profile; Permit, Deny - Edge-Core ECS4810-12M Layer 2 Management Manual

R
ELATED
show ipv6 mld filter
This command creates an MLD filter profile number and enters MLD profile

ipv6 mld profile

configuration mode. Use the no form to delete a profile number.
S
YNTAX
[no] ipv6 mld profile profile-number
D
EFAULT
Disabled
C
OMMAND
Global Configuration
C
OMMAND
A profile defines the multicast groups that a subscriber is permitted or
denied to join. The same profile can be applied to many interfaces, but only
one profile can be assigned to one interface. Each profile has only one
access mode; either permit or deny.
E
XAMPLE
Console(config)#ipv6 mld profile 19
Console(config-mld-profile)#
R
ELATED
show ipv6 mld profile
This command sets the access mode for an MLD filter profile. Use the no

permit, deny

form to delete a profile number.
S
YNTAX
{permit | deny}
D
EFAULT
deny
C
OMMAND
MLD Profile Configuration
C
OMMAND
◆ Each profile has only one access mode; either permit or deny.
C
OMMANDS
profile-number - An MLD filter profile number.
(Range: 1-4294967295)
S
ETTING
M
ODE
U
SAGE
C
OMMANDS
S
ETTING
M
ODE
U
SAGE
– 1225 –
| Multicast Filtering Commands
C 39
HAPTER
MLD Filtering and Throttling