Sntp Poll; Sntp Server - Edge-Core ECS4810-12M Layer 2 Management Manual

| System Management Commands
C 20
HAPTER
Time

sntp poll

sntp server

This command sets the interval between sending time requests when the
switch is set to SNTP client mode. Use the no form to restore to the
default.
S
YNTAX
sntp poll seconds
no sntp poll
seconds - Interval between time requests.
(Range: 16-16384 seconds)
D S
EFAULT ETTING
16 seconds
C M
OMMAND ODE
Global Configuration
E
XAMPLE
Console(config)#sntp poll 60
Console#
R C
ELATED OMMANDS
sntp client (737)
This command sets the IP address of the servers to which SNTP time
requests are issued. Use the this command with no arguments to clear all
time servers from the current list. Use the no form to clear all time servers
from the current list, or to clear a specific server.
S
YNTAX
sntp server [ip1 [ip2 [ip3]]]
no sntp server [ip1 [ip2 [ip3]]]
ip - IPv4 or IPv6 address of a time server (NTP or SNTP).
(Range: 1 - 3 addresses)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command specifies time servers from which the switch will poll for
time updates when set to SNTP client mode. The client will poll the time
servers in the order specified until a response is received. It issues time
synchronization requests based on the interval set via the
command.
– 738 –
sntp poll