Erps; Erps Domain - Edge-Core ECS4810-12M Layer 2 Management Manual

Enable an ERPS ring: Before an ERPS ring can work, it must be enabled
7.
using the
ring enabled, R-APS messages will start flowing in the control VLAN,
and normal traffic will begin to flow in the data VLANs. To stop a ring, it
can be disabled on any node using the
Display ERPS status information: Use the
8.
display general ERPS status information or detailed ERPS status
information for a specific ring.
This command enables ERPS on the switch. Use the no form to disable this

erps

feature.
S
YNTAX
[no] erps
D
EFAULT
Disabled
C
OMMAND
Global Configuration
C
OMMAND
ERPS must be enabled globally on the switch before it can enabled on an
ERPS ring using the
E
XAMPLE
Console(config)#erps
Console(config)#
R
ELATED
enable (1071)
This command creates an ERPS ring and enters ERPS configuration mode

erps domain

for the specified domain. Use the no form to delete a ring.
S
YNTAX
erps domain ring-name [id ring-id]
no erps domain ring-name
D
EFAULT
None
enable command. When configuration is completed and the
S
ETTING
M
ODE
U
SAGE
enable command.
C
OMMANDS
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
ring-id - ERPS ring identifier used in R-APS messages.
(Range: 1-255)
S
ETTING
– 1069 –
| ERPS Commands
C 35
HAPTER
no enable command.
show erps command to