Mvr6 Proxy-Query-Interval; Mvr6 Proxy-Switching - Edge-Core ECS4810-12M Layer 2 Management Manual

| Multicast Filtering Commands
C 39
HAPTER
MVR for IPv6
mvr6
proxy-query-interval
mvr6
proxy-switching
The MVR6 group address range assigned to a profile cannot overlap
◆
with the group address range of any other profile.
E
XAMPLE
The following example maps a range of MVR6 group addresses to a profile:
Console(config)#mvr6 profile rd ff01:0:0:0:0:0:0:fe ff01:0:0:0:0:0:0:ff
Console(config)#
This command configures the interval at which the receiver port sends out
general queries. Use the no form to restore the default setting.
S
YNTAX
mvr proxy-query-interval interval
no mvr proxy-query-interval
interval - The interval at which the receiver port sends out general
queries. (Range: 2-31744 seconds)
D S
EFAULT ETTING
125 seconds
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command sets the general query interval at which active receiver
ports send out general queries. This interval is only effective when proxy
switching is enabled with the
E
XAMPLE
This example sets the proxy query interval for MVR6.
Console(config)#mvr6 proxy-query-interval 1000
Console(config)#
This command enables MVR proxy switching, where the source port acts as
a host, and the receiver port acts as an MVR router with querier service
enabled. Use the no form to disable this function.
S
YNTAX
[no] mvr6 proxy-switching
D S
EFAULT ETTING
Enabled
– 1258 –

mvr6 proxy-switching

command.