Snmp Commands; Table 66: Snmp Commands - Edge-Core ECS4810-12M Layer 2 Management Manual

21
SNMP C
OMMANDS
SNMP commands control access to this switch from management stations
using the Simple Network Management Protocol (SNMP), as well as the
error types sent to trap managers.
SNMP Version 3 also provides security features that cover message
integrity, authentication, and encryption; as well as controlling user access
to specific areas of the MIB tree. To use SNMPv3, first set an SNMP engine
ID (or accept the default), specify read and write access views for the MIB
tree, configure SNMP user groups with the required security model (i.e.,
SNMP v1, v2c or v3) and security level (i.e., authentication and privacy),
and then assign SNMP users to these groups, along with their specific
authentication and privacy passwords.

Table 66: SNMP Commands

Command Function
General SNMP Commands
snmp-server Enables the SNMP agent
snmp-server community Sets up the community access string to permit access
to SNMP commands
snmp-server contact Sets the system contact string
snmp-server location Sets the system location string
show snmp Displays the status of SNMP communications
SNMP Target Host Commands
snmp-server enable traps Enables the device to send SNMP traps (i.e., SNMP
notifications)
snmp-server host Specifies the recipient of an SNMP notification
operation
SNMPv3 Engine Commands
snmp-server engine-id Sets the SNMP engine ID
snmp-server group Adds an SNMP group, mapping users to views
snmp-server user Adds a user to an SNMP group
snmp-server view Adds an SNMP view
show snmp engine-id Shows the SNMP engine ID
show snmp group Shows the SNMP groups
show snmp user Shows the SNMP users
show snmp view Shows the SNMP views
– 765 –
Mode
GC
GC
GC
GC
NE, PE
GC
GC
GC
GC
GC
GC
PE
PE
PE
PE