Configuring Snmpv3 Groups - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

To show the OID branches configured for the SNMP views of the switch's

MIB database:

Figure 251: Showing the OID Subtree Configured for SNMP Views

Use the Administration > SNMP (Configure Group) page to add an SNMPv3

group which can be used to set the access policy for its assigned users,

restricting them to specific read, write, and notify views. You can use the

pre-defined default groups or create new groups to map a set of SNMP

users to SNMP views.

These parameters are displayed:

Click Administration, SNMP.

Select Configure View from the Step list.

Select Show OID Subtree from the Action list.

Select a view name from the list of existing views.

"show snmp group" on page 779

Group Name – The name of the SNMP group to which the user is

assigned. (Range: 1-32 characters)

Security Model – The user security model; SNMP v1, v2c or v3.

Security Level – The following security levels are only used for the

groups assigned to the SNMP security model:

noAuthNoPriv – There is no authentication or encryption used in

SNMP communications. (This is the default security level.)

AuthNoPriv – SNMP communications use authentication, but the

data is not encrypted.

AuthPriv – SNMP communications use both authentication and

| Basic Administration Protocols

Simple Network Management Protocol

Chapters

Table of Contents