Edge-Core ECS4810-12M Layer 2 Management Manual page 369

Source/Destination Prefix-Length – A decimal value indicating how
◆
many contiguous bits (from the left) of the address comprise the prefix;
i.e., the network portion of the address. (Range: 0-128 bits for the
source prefix; 0-8 bits for the destination prefix)
DSCP – DSCP traffic class. (Range: 0-63)
◆
Next Header – Identifies the type of header immediately following the
◆
IPv6 header. (Range: 0-255)
Optional internet-layer information is encoded in separate headers that
may be placed between the IPv6 header and the upper-layer header in
a packet. There are a small number of such extension headers, each
identified by a distinct Next Header value. IPv6 supports the values
defined for the IPv4 Protocol field in RFC 1700, and includes these
commonly used headers:
0 : Hop-by-Hop Options (RFC 2460)
6 : TCP Upper-layer Header (RFC 1700)
17 : UDP Upper-layer Header (RFC 1700)
43 : Routing (RFC 2460)
44 : Fragment (RFC 2460)
50 : Encapsulating Security Payload (RFC 2406)
51 : Authentication (RFC 2402)
60 : Destination Options (RFC 2460)
Time Range – Name of a time range.
◆
W I
EB NTERFACE
To add rules to an Extended IPv6 ACL:
Click Security, ACL.
1.
Select Configure ACL from the Step list.
2.
Select Add Rule from the Action list.
3.
Select IPv6 Extended from the Type list.
4.
Select the name of an ACL from the Name list.
5.
Specify the action (i.e., Permit or Deny).
6.
Select the address type (Any or IPv6-prefix).
7.
If you select "Host," enter a specific address. If you select "IPv6-prefix,"
8.
enter a subnet address and prefix length.
Set any other required criteria, such as DSCP or next header type.
9.
Click Apply.
10.
– 369 –
| Security Measures
C 13
HAPTER
Access Control Lists