Ma Index Name-Format; Ethernet Cfm Mep - Edge-Core ECS4810-12M Layer 2 Management Manual

E
This example creates a maintenance association, binds it to VLAN 1, and
allows MIPs to be created within this MA using the default method.
This command specifies the name format for the maintenance association
ma index
as IEEE 802.1ag character based, or ITU-T SG13/SG15 Y.1731 defined ICC-
name-format
based format. Use the no form to restore the default setting.
S
D
character-string
C
CFM Domain Configuration
E
This example specifies the name format as character string.
This command sets an interface as a domain boundary, defines it as a

ethernet cfm mep

maintenance end point (MEP), and sets direction of the MEP in regard to
sending and receiving CFM messages. Use the no form to delete a MEP.
S
XAMPLE
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#ma index 1 name rd vlan 1 mip-creation default
Console(config-ether-cfm)#
YNTAX
ma index index name-format {character-string | icc-based}
no ma index index name-format
index – MA identifier. (Range: 1-2147483647)
character-string – IEEE 802.1ag defined character string format.
This is an IETF RFC 2579 DisplayString.
icc-based – ITU-T SG13/SG15 Y.1731 defined ICC based format.
S
EFAULT ETTING
M
OMMAND ODE
XAMPLE
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#ma index 1 name-format character-string
Console(config-ether-cfm)#
YNTAX
ethernet cfm mep mpid mpid md domain-name ma ma-name [up]
no ethernet cfm mep mpid mpid ma ma-name
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
– 1307 –
| CFM Commands
C 41
HAPTER
Defining CFM Structures