Edge-Core ECS4810-12M Layer 2 Management Manual page 651

All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
◆
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
The MVR6 VLAN cannot be specified as the receiver VLAN for static
◆
bindings.
P
ARAMETERS
These parameters are displayed:
Domain ID – An independent multicast domain. (Range: 1-5)
◆
Interface – Port or trunk identifier.
◆
◆ VLAN – VLAN identifier. (Range: 1-4094)
Group IPv6 Address – Defines a multicast service sent to the selected
◆
port. Multicast groups must be assigned from the MVR6 group range
configured on the Configure General page.
W I
EB NTERFACE
To assign a static MVR6 group to an interface:
Click Multicast, MVR6.
1.
Select Configure Static Group Member from the Step list.
2.
Select Add from the Action list.
3.
Select an MVR6 domain.
4.
Select a VLAN and interface to receive the multicast stream, and then
5.
enter the multicast group address.
Click Apply.
6.
Figure 391: Assigning Static MVR6 Groups to a Port
– 651 –
| Multicast Filtering
C 17
HAPTER
Multicast VLAN Registration for IPv6