Mvr6 Vlan; Mvr6 Immediate-Leave - Edge-Core ECS4810-12M Layer 2 Management Manual

| Multicast Filtering Commands
C 39
HAPTER
MVR for IPv6

mvr6 vlan

mvr6
immediate-leave
This command specifies the VLAN through which MVR multicast data is
received. Use the no form of this command to restore the default MVR
VLAN.
S
YNTAX
mvr6 domain domain-id vlan vlan-id
no mvr6 domain domain-id vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR multicast data is
received. This is also the VLAN to which all source ports must be
assigned. (Range: 1-4093)
D S
EFAULT ETTING
VLAN 1
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
MVR source ports can be configured as members of the MVR VLAN using
the switchport allowed vlan
command, but MVR receiver ports should not be statically configured as
members of this VLAN.
E
XAMPLE
The following example sets the MVR6 VLAN to VLAN 1:
Console(config)#mvr6 domain 1 vlan 1
Console(config)#
This command causes the switch to immediately remove an interface from
a multicast stream as soon as it receives a leave message for that group.
Use the no form to restore the default settings.
S
YNTAX
[no] mvr6 domain domain-id immediate-leave
domain-id - An independent multicast domain. (Range: 1-5)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
– 1262 –
command and switchport native vlan