Cross Check Operations; Ethernet Cfm Mep Crosscheck Start-Delay; Table 185: Show Ethernet Cfm Errors - Display Description - Edge-Core ECS4810-12M Layer 2 Management Manual

| CFM Commands
C 41
HAPTER

Cross Check Operations

Cross Check Operations
ethernet cfm mep
crosscheck
start-delay
E
XAMPLE
Console#show ethernet cfm errors
Level VLAN MPID Interface Remote MAC
----- ---- ---- --------- ----------------- ---------------- ----------------
5 2 40 Eth 1/1
Console#

Table 185: show ethernet cfm errors - display description

Field Description
Level Maintenance level associated with this entry.
VLAN VLAN in which this error occurred.
MPID Identifier of remote MEP.
Interface Port at which the error was recorded
Remote MAC MAC address of remote MEP.
Reason Error types include:
LEAK – MA x is associated with a specific VID list
the VIDs in this MA can pass through the bridge port, no MEP is
configured facing outward (down) on any bridge port for this MA,
and some other MA y, at a higher maintenance level, and associated
with at least one of the VID(s) also in MA x, does have a MEP
configured on the bridge port.
VIDS – MA x is associated with a specific VID list
bridge port, and some other MA y, associated with at least one of the
VID(s) also in MA x, also has an Up MEP configured facing inward
(up) on some bridge port.
EXCESS_LEV – The number of different MD levels at which MIPs are
to be created on this port exceeds the bridge's capabilities.
OVERLAP_LEV – A MEP is created for one VID at one maintenance
level, but a MEP is configured on another VID at an equivalent or
higher level, exceeding the bridge's capabilities.
MA The maintenance association for this entry.
* This definition is based on the IEEE 802.1ag standard. Current software for this switch
only supports a single VLAN per MA. However, since it may interact with other devices
which support multiple VLAN assignments per MA, this error message may be
reported.
This command sets the maximum delay that a device waits for remote
MEPs to come up before starting the cross-check operation. Use the no
form to restore the default setting.
S
YNTAX
ethernet cfm mep crosscheck start-delay delay
delay – The time a device waits for remote MEPs to come up before
the cross-check is started. (Range: 1-65535 seconds)
D S
EFAULT ETTING
30 seconds
– 1322 –
Reason
ab.2f.9c.00.05.01 LEAK
MA Name
provider_1_2
* , one or more of
on this MA on the
*