Priority; Set Cos - Edge-Core ECS4810-12M Layer 2 Management Manual

This command sets the priority for the designated traffic flow. Use the no

priority

form to restore the default setting.
S
YNTAX
priority priority
no priority
priority - Priority assigned to designated traffic flow.
(Range: 0-1000)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Policy Map Class Configuration
C U
OMMAND SAGE
This command is used to set the priority of a policy-based class map.
E
XAMPLE
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#priority 100
Console(config-pmap-c)#
This command modifies the class of service (CoS) value for a matching

set cos

packet (as specified by the
the no form to remove this setting.
S
YNTAX
[no] set cos cos-value
cos-value - Class of Service value. (Range: 0-7)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Policy Map Class Configuration
C U
OMMAND SAGE
The set cos command is used to set the CoS value in the VLAN tag for
◆
matching packets.
The set cos and
◆
priority. Therefore setting either of these commands will overwrite any
action already configured by the other command.
C 38
HAPTER
match command) in the packet's VLAN tag. Use
set phb command function at the same level of
– 1171 –
| Quality of Service Commands