Ethernet Cfm Port-Enable - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| CFM Commands

Defining CFM Structures

ethernet cfm

ma-name – Maintenance association name. (Range: 1-43

alphanumeric characters)

up – Indicates that the MEP faces inward toward the switch cross-

connect matrix, and transmits CFM messages towards, and receives

them from, the direction of the internal bridge relay mechanism. If

the up keyword is not included in this command, then the MEP is

facing away from the switch, and transmits CFM messages towards,

and receives them from, the direction of the physical medium.

No MEPs are configured.

The MEP faces outward (down).

Interface Configuration (Ethernet, Port Channel)

CFM elements must be configured in the following order: (1)

maintenance domain at the same level as the MEP to be configured

ethernet cfm domain

association within the domain (using the

and (3) finally the MEP using this command.

An interface may belong to more than one domain. This command can

be used to configure an interface as a MEP for different MAs in different

To change the MEP's MA or the direction it faces, first delete the MEP,

and then create a new one.

This example sets port 1 as a DSAP for the specified maintenance

association.

Console(config)#interface ethernet 1/1

Console(config-if)#ethernet cfm mep mpid 1 md voip ma rd

Console(config-if)#

This command enables CFM processing on an interface. Use the no form to

disable CFM processing on an interface.

[no] ethernet cfm port-enable

Interface Configuration (Ethernet, Port Channel)

command), (2) maintenance

ma index name

Chapters

Table of Contents