Configuring An Arp Acl - Edge-Core ECS4810-12M Layer 2 Management Manual

| Security Measures
C 13
HAPTER
Access Control Lists
C
ONFIGURING
ARP ACL
AN
Figure 200: Configuring a MAC ACL
Use the Security > ACL (Configure ACL - Add Rule - ARP) page to configure
ACLs based on ARP message addresses. ARP Inspection can then use these
ACLs to filter suspicious traffic (see
Inspection" on page 379).
CLI R
EFERENCES
"permit, deny (ARP ACL)" on page 944
◆
"show ip access-list" on page 931
◆
"Time Range" on page 745
◆
P
ARAMETERS
These parameters are displayed:
Type – Selects the type of ACLs to show in the Name list.
◆
Name – Shows the names of ACLs matching the selected type.
◆
Action – An ACL can contain any combination of permit or deny rules.
◆
◆ Packet Type – Indicates an ARP request, ARP response, or either type.
(Range: IP, Request, Response, All; Default: IP)
◆ Source/Destination IP Address Type – Specifies the source or
destination IPv4 address. Use "Any" to include all possible addresses,
"Host" to specify a specific host address in the Address field, or "IP" to
specify a range of addresses with the Address and Mask fields.
(Options: Any, Host, IP; Default: Any)
Source/Destination IP Address – Source or destination IP address.
◆
– 372 –
"Configuring Global Settings for ARP