Configuring Lldp Interface Civic-Address; Table 25: Lldp Med Location Ca Types - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

Use the Administration > LLDP (Configure Interface – Add CA-Type) page

to specify the physical location of the device attached to an interface.

These parameters are displayed:

To specify the physical location of the attached device:

"lldp med-location civic-addr" on page 1286

Use the Civic Address type (CA-Type) to advertise the physical location

of the device attached to an interface, including items such as the city,

street number, building and room information. The address location is

specified as a type and value pair, with the civic address type defined in

RFC 4776. The following table describes some of the CA type numbers

and provides examples.

CA Type Description

National subdivisions (state, canton, province)

County, parish

City, township

City division, borough, city district

Neighborhood, block

Group of streets below the neighborhood level

Street suffix or type

House number

House number suffix

Landmark or vanity address

Unit (apartment, suite)

Any number of CA type and value pairs can be specified for the civic

address location, as long as the total does not exceed 250 characters.

CA-Type – Descriptor of the data civic address value. (Range: 0-255)

CA-Value – Description of a location. (Range: 1-32 characters)

Click Administration, LLDP.

Select Configure Interface from the Step list.

| Basic Administration Protocols

Link Layer Discovery Protocol

CA Value Example

Chapters

Table of Contents