Edge-Core ECS4810-12M Layer 2 Management Manual page 560

| IP Configuration
C 15
HAPTER
Using the Ping Function
C U
OMMAND SAGE
◆ Use the ping command to see if another site on the network can be
reached.
The following are some results of the ping command:
◆
Normal response - The normal response occurs in one to ten
■
seconds, depending on network traffic.
Destination does not respond - If the host does not respond, a
■
"timeout" appears in ten seconds.
Destination unreachable - The gateway for this destination indicates
■
that the destination is unreachable.
Network or host unreachable - The gateway found no corresponding
■
entry in the route table.
W I
EB NTERFACE
To ping another device on the network:
Click IP, General, Ping.
1.
Specify the target device and ping parameters.
2.
Click Apply.
3.
Figure 322: Pinging a Network Device
– 560 –