Edge-Core ECS4810-12M Layer 2 Management Manual page 646

| Multicast Filtering
C 17
HAPTER
Multicast VLAN Registration for IPv6
C U
OMMAND SAGE
◆ Use the Configure Profile page to statically configure all multicast group
addresses that will join the MVR6 VLAN. Any multicast data associated
with an MVR6 group is sent from all source ports to all receiver ports
that have registered to receive data from that multicast group.
◆ All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields. (Note that the IP
address ff02::X is reserved.)
The MVR6 group address range assigned to a profile cannot overlap
◆
with the group address range of any other profile.
MRV6 domains can be associated with more than one MVR6 profile. But
◆
since MVR6 domains cannot share the group range, an MRV6 profile
can only be associated with one MVR6 domain.
P
ARAMETERS
These parameters are displayed:
Configure Profile
Profile Name – The name of a profile containing one or more MVR6
◆
group addresses. (Range: 1-21 characters)
Start IPv6 Address – Starting IP address for an MVR6 multicast
◆
group. This parameter must be a full IPv6 address including the
network prefix and host address bits.
End IPv6 Address – Ending IP address for an MVR6 multicast group.
◆
This parameter must be a full IPv6 address including the network prefix
and host address bits.
Associate Profile
Domain ID – An independent multicast domain. (Range: 1-5)
◆
Profile Name – The name of a profile to be assigned to this domain.
◆
(Range: 1-21 characters)
W I
EB NTERFACE
To configure an MVR6 group address profile:
Click Multicast, MVR6.
1.
Select Configure Profile from the Step list.
2.
Select Add from the Action list.
3.
Enter the name of a group profile to be assigned to one or more
4.
domains, and specify a multicast group that will stream traffic to
participating hosts.
– 646 –