Show Ethernet Cfm Fault-Notify-Generator; Table 189: Show Fault-Notify-Generator - Display Description - Edge-Core ECS4810-12M Layer 2 Management Manual

This command displays configuration settings for the fault notification
show ethernet cfm
generator.
fault-notify-
generator
S
D
None
C
Privileged Exec
E
This example shows the fault notification settings configured for one MEP.

Table 189: show fault-notify-generator - display description

Field
MD Name
MA Name
Hihest Defect
Lowest Alarm
Alarm Time
Reset Time
YNTAX
show ethernet cfm fault-notify-generator mep mpid
mpid – Maintenance end point identifier. (Range: 1-8191)
S
EFAULT ETTING
M
OMMAND ODE
XAMPLE
Console#show ethernet cfm fault-notify-generator mep 1
MD Name MA Name
------------ ------------ -------------- ------------- ---------- ----------
voip rd none
Console#
Description
The maintenance domain for this entry.
The maintenance association for this entry.
The highest defect that will generate a fault alarm. (This is disabled
by default.)
The lowest defect that will generate a fault alarm (see the
notify lowest-priority
The time a defect must exist before a fault alarm is issued (see the
mep fault-notify
The time after a fault alarm has been issued, and no defect exists,
before another fault alarm can be issued (see the
reset-time
– 1335 –
C
HAPTER
Highest Defect Lowest Alarm
macRemErrXcon
command).
alarm-time, command).
command).
| CFM Commands
41
Fault Generator Operations
Alarm Time Reset Time
3sec. 10sec.
mep fault-
mep fault-notify