Cluster Member Configuration - Edge-Core ECS4810-12M Layer 2 Management Manual

W
EB
To configure a switch cluster:
1.
2.
3.
4.
Figure 277: Configuring a Switch Cluster
Use the Administration > Cluster (Configure Member - Add) page to add
C M
LUSTER EMBER
Candidate switches to the cluster as Members.
C
ONFIGURATION
CLI R
◆
P
ARAMETERS
These parameters are displayed:
◆
◆
I
NTERFACE
Click Administration, Cluster.
Select Configure Global from the Step list.
Set the required attributes for a Commander or a managed candidate.
Click Apply
EFERENCES
"Switch Clustering" on page 758
Member ID – Specify a Member ID number for the selected Candidate
switch. (Range: 1-36)
MAC Address – Select a discovered switch MAC address from the
Candidate Table, or enter a specific MAC address of a known switch.
– 485 –
| Basic Administration Protocols
C 14
HAPTER
Switch Clustering