Edge-Core ECS4810-12M Layer 2 Management Manual page 367

Action – An ACL can contain any combination of rules which permit or
◆
deny a packet.
Source Address Type – Specifies the source IP address. Use "Any" to
◆
include all possible addresses, "Host" to specify a specific host address
in the Address field, or "IPv6-Prefix" to specify a range of addresses.
(Options: Any, Host, IPv6-Prefix; Default: Any)
Source IPv6 Address – An IPv6 source address or network class. The
◆
address must be formatted according to RFC 2373 "IPv6 Addressing
Architecture," using 8 colon-separated 16-bit hexadecimal values. One
double colon may be used in the address to indicate the appropriate
number of zeros required to fill the undefined fields.
Source Prefix-Length – A decimal value indicating how many
◆
contiguous bits (from the left) of the address comprise the prefix (i.e.,
the network portion of the address). (Range: 0-128 bits)
Time Range – Name of a time range.
◆
W I
EB NTERFACE
To add rules to a Standard IPv6 ACL:
Click Security, ACL.
1.
Select Configure ACL from the Step list.
2.
Select Add Rule from the Action list.
3.
Select IPv6 Standard from the Type list.
4.
Select the name of an ACL from the Name list.
5.
Specify the action (i.e., Permit or Deny).
6.
Select the source address type (Any, Host, or IPv6-prefix).
7.
If you select "Host," enter a specific address. If you select "IPv6-prefix,"
8.
enter a subnet address and the prefix length.
Click Apply.
9.
– 367 –
| Security Measures
C 13
HAPTER
Access Control Lists