Show Mac-Vlan; Configuring Voice Vlans; Table 145: Voice Vlan Commands - Edge-Core ECS4810-12M Layer 2 Management Manual

show mac-vlan

C V
ONFIGURING OICE
When MAC-based, IP subnet-based, and protocol-based VLANs are
◆
supported concurrently, priority is applied in this sequence, and then
port-based VLANs last.
E
XAMPLE
The following example assigns traffic from source MAC address 00-00-00-
11-22-33 to VLAN 10.
Console(config)#mac-vlan mac-address 00-00-00-11-22-33 vlan 10
Console(config)#
This command displays MAC address-to-VLAN assignments.
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
Use this command to display MAC address-to-VLAN mappings.
E
XAMPLE
The following example displays all configured MAC address-based VLANs.
Console#show mac-vlan
MAC Address VLAN ID
----------------- --------
00-00-00-11-22-33
Console#
VLAN
S
The switch allows you to specify a Voice VLAN for the network and set a
CoS priority for the VoIP traffic. VoIP traffic can be detected on switch ports
by using the source MAC address of packets, or by using LLDP (IEEE
802.1AB) to discover connected VoIP devices. When VoIP traffic is detected
on a configured port, the switch automatically assigns the port to the Voice
VLAN. Alternatively, switch ports can be manually configured.

Table 145: Voice VLAN Commands

Command Function
voice vlan Defines the Voice VLAN ID
voice vlan aging Configures the aging time for Voice VLAN ports
voice vlan mac-address Configures VoIP device MAC addresses
switchport voice vlan Sets the Voice VLAN port mode
switchport voice vlan Sets the VoIP traffic priority for ports
priority
– 1135 –
C
HAPTER
Priority
--------
10 0
| VLAN Commands
36

Configuring Voice VLANs

Mode
GC
GC
GC
IC
IC