Command Line Processing; Showing Status Information; Table 43: Keystroke Commands - Edge-Core ECS4810-12M Layer 2 Management Manual

| Using the Command Line Interface
C 18
HAPTER
Entering Commands
C L
OMMAND INE
P
ROCESSING
S S
HOWING TATUS
I
NFORMATION
Commands are not case sensitive. You can abbreviate commands and
parameters as long as they contain enough letters to differentiate them
from any other currently available commands or parameters. You can use
the Tab key to complete partial commands, or enter a partial command
followed by the "?" character to display a list of possible matches. You can
also use the following editing keystrokes for command-line processing:

Table 43: Keystroke Commands

Keystroke Function
Ctrl-A Shifts cursor to start of command line.
Ctrl-B Shifts cursor to the left one character.
Ctrl-C Terminates the current task and displays the command prompt.
Ctrl-E Shifts cursor to end of command line.
Ctrl-F Shifts cursor to the right one character.
Ctrl-K Deletes all characters from the cursor to the end of the line.
Ctrl-L Repeats current command line on a new line.
Ctrl-N Enters the next command line in the history buffer.
Ctrl-P Enters the last command.
Ctrl-R Repeats current command line on a new line.
Ctrl-U Deletes from the cursor to the beginning of the line.
Ctrl-W Deletes the last word typed.
Esc-B Moves the cursor back one word.
Esc-D Deletes from the cursor to the end of the word.
Esc-F Moves the cursor forward one word.
Delete key or Erases a mistake when entering a command.
backspace key
There are various "show" commands which display configuration settings
or the status of specified processes. Many of these commands will not
display any information unless the switch is properly configured, and in
some cases the interface to which a command applies is up.
For example, if a static router port is configured, the corresponding show
command will not display any information unless IGMP snooping is
enabled, and the link for the static router port is up.
Console#configure
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11
Console(config)#end
Console#show ip igmp snooping mrouter
VLAN M'cast Router Ports Type
---- ------------------- -------
Console#configure
Console(config)#ip igmp snooping
Console(config)#end
Console#show ip igmp snooping mrouter
– 670 –