Mvr6 Domain; Mvr6 Priority - Edge-Core ECS4810-12M Layer 2 Management Manual

| Multicast Filtering Commands
C 39
HAPTER
MVR for IPv6

mvr6 domain

mvr6 priority

E
XAMPLE
The following an MVR6 group address profile to domain 1:
Console(config)#mvr6 domain 1 associated-profile rd
Console(config)#
This command enables Multicast VLAN Registration (MVR) for a specific
domain. Use the no form of this command to disable MVR for a domain.
S
YNTAX
[no] mvr6 domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
When MVR6 is enabled on a domain, any multicast data associated with an
MVR6 group is sent from all designated source ports, to all receiver ports
that have registered to receive data from that multicast group.
E
XAMPLE
The following example enables MVR6 for domain 1:
Console(config)#mvr6 domain 1
Console(config)#
This command assigns a priority to all multicast traffic in the MVR VLAN.
Use the no form of this command to restore the default setting.
S
YNTAX
mvr priority priority
no mvr priority
priority - The CoS priority assigned to all multicast traffic forwarded
into the MVR VLAN. (Range: 0-7, where 7 is the highest priority)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
– 1256 –