Configuring Ip Subnet Vlans; Table 143: Ip Subnet Vlan Commands - Edge-Core ECS4810-12M Layer 2 Management Manual

C IP S
ONFIGURING UBNET
port-channel channel-id (Range: 1-12)
D S
EFAULT ETTING
The mapping for all interfaces is displayed.
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
This shows that traffic entering Port 1 that matches the specifications for
protocol group 1 will be mapped to VLAN 2:
Console#show interfaces protocol-vlan protocol-group
Port ProtocolGroup ID
---------- ------------------ -----------
Eth 1/1
Console#
VLAN
S
When using IEEE 802.1Q port-based VLAN classification, all untagged
frames received by a port are classified as belonging to the VLAN whose
VID (PVID) is associated with that port.
When IP subnet-based VLAN classification is enabled, the source address of
untagged ingress frames are checked against the IP subnet-to-VLAN
mapping table. If an entry is found for that subnet, these frames are
assigned to the VLAN indicated in the entry. If no IP subnet is matched, the
untagged frames are classified as belonging to the receiving port's VLAN ID
(PVID).

Table 143: IP Subnet VLAN Commands

Command
subnet-vlan
show interfaces subnet-vlan
show subnet-vlan
– 1131 –
C
HAPTER
VLAN ID
1 vlan2
Function
Defines the IP Subnet VLANs
Displays a brief summary of IP Subnet VLAN settings
Displays IP Subnet VLAN settings
| VLAN Commands
36

Configuring IP Subnet VLANs

Mode
GC
PE
PE