Table 42: Configuration Command Modes - Edge-Core ECS4810-12M Layer 2 Management Manual

To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to
"Console(config)#" which gives you access privilege to all Global
Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.

Table 42: Configuration Command Modes

Mode Command
Access access-list arp
Control List
access-list ip standard
access-list ip extended
access-list ipv6 standard
access-list ipv6 extended
access-list mac
CFM ethernet cfm domain
Class Map class-map
ERPS erps domain
Interface interface {ethernet port |
port-channel id| vlan id}
Line line {console | vty}
MSTP spanning-tree mst-configuration
Policy Map policy-map
Time Range time-range
VLAN vlan database
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#
– 669 –
| Using the Command Line Interface
C 18
HAPTER
Prompt
Console(config-arp-acl)
Console(config-std-acl)
Console(config-ext-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
Console(config-mac-acl)
Console(config-ether-cfm)
Console(config-cmap)
Console(config-erps)
Console(config-if)
Console(config-line)
Console(config-mstp)
Console(config-pmap)
Console(config-time-range)
Console(config-vlan)
Entering Commands
Page
943
926
926
932
932
938
1303
1158
1069
950
715
1046
1162
745
1105