Stopbits - Edge-Core ECS4810-12M Layer 2 Management Manual

| System Management Commands
C 20
HAPTER
Line

stopbits

D S
EFAULT ETTING
115200 bps
C M
OMMAND ODE
Line Configuration
C U
OMMAND SAGE
Set the speed to match the baud rate of the device connected to the serial
port. Some baud rates available on devices connected to the port might not
be supported. The system indicates if the speed you selected is not
supported.
E
XAMPLE
To specify 57600 bps, enter this command:
Console(config-line)#speed 57600
Console(config-line)#
This command sets the number of the stop bits transmitted per byte. Use
the no form to restore the default setting.
S
YNTAX
stopbits {1 | 2}
no stopbits
1 - One stop bit
2 - Two stop bits
D S
EFAULT ETTING
1 stop bit
C M
OMMAND ODE
Line Configuration
E
XAMPLE
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#
– 722 –