No Rspan Session; Show Rspan - Edge-Core ECS4810-12M Layer 2 Management Manual

E
XAMPLE
The following example enables RSPAN on VLAN 2, specifies this device as
an RSPAN destination switch, and the uplink interface as port 3:
Use this command to delete a configured RSPAN session.

no rspan session

S
YNTAX
C
OMMAND
Global Configuration
C
OMMAND
The no rspan session command must be used to disable an RSPAN VLAN
before it can be deleted from the VLAN database (see the
E
XAMPLE
Use this command to displays the configuration settings for an RSPAN

show rspan

session.
S
YNTAX
C
OMMAND
Privileged Exec
show vlan command will not display any members for an RSPAN VLAN,
but will only show configured RSPAN VLAN identifiers.
Console(config)#rspan session 1 remote vlan 2 destination uplink ethernet 1/3
Console(config)#
no rspan session session-id
session-id – A number identifying this RSPAN session. (Range: 1)
Only one mirror session is allowed, including both local and remote
mirroring. If local mirroring is enabled with the
command, then no session can be configured for RSPAN.
M
ODE
U
SAGE
Console(config)#no rspan session 1
Console(config)#
show rspan session [session-id]
session-id – A number identifying this RSPAN session. (Range: 1)
Only one mirror session is allowed, including both local and remote
mirroring. If local mirroring is enabled with the
command, then no session can be configured for RSPAN.
M
ODE
– 1001 –
| Port Mirroring Commands
C 29
HAPTER
RSPAN Mirroring Commands
port monitor
vlan
port monitor
command).