Ipv6 Mld Snooping Vlan Mrouter - Edge-Core ECS4810-12M Layer 2 Management Manual

◆
E
The following shows how to enable MLD immediate leave.
This command statically configures an IPv6 multicast router port. Use the
ipv6 mld snooping
no form to remove the configuration.
vlan mrouter
S
D
No static multicast router ports are configured.
C
Global Configuration
C
Depending on your network connections, MLD snooping may not always be
able to locate the MLD querier. Therefore, if the MLD querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on the switch, you can manually configure that interface to join all
the current multicast groups.
group only if no host replies to the query within the specified timeout
period.
If MLD immediate-leave is enabled, the switch assumes that only one
host is connected to the interface. Therefore, immediate leave should
only be enabled on an interface if it is connected to only one MLD-
enabled device, either a service host or a neighbor running MLD
snooping.
XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ipv6 mld snooping immediate-leave
Console(config-if)#
YNTAX
[no] ipv6 mld snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4093)
interface
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
– 1219 –
| Multicast Filtering Commands
C 39
HAPTER
MLD Snooping