Dot1X System-Auth-Control; Authenticator Commands; Dot1X Intrusion-Action - Edge-Core ECS4810-12M Layer 2 Management Manual

dot1x system-
auth-control

Authenticator Commands

dot1x
intrusion-action
E
XAMPLE
This example instructs the switch to pass all EAPOL frame through to any
ports in STP forwarding state.
Console(config)#dot1x eapol-pass-through
Console(config)#
This command enables IEEE 802.1X port authentication globally on the
switch. Use the no form to restore the default.
S
YNTAX
[no] dot1x system-auth-control
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
E
XAMPLE
Console(config)#dot1x system-auth-control
Console(config)#
This command sets the port's response to a failed authentication, either to
block all traffic, or to assign all traffic for the port to a guest VLAN. Use the
no form to reset the default.
S
YNTAX
dot1x intrusion-action {block-traffic | guest-vlan}
no dot1x intrusion-action
block-traffic - Blocks traffic on this port.
guest-vlan - Assigns the user to the Guest VLAN.
D
EFAULT
block-traffic
C M
OMMAND ODE
Interface Configuration
– 839 –
| Authentication Commands
C 24
HAPTER
802.1X Port Authentication