Transceiver-Threshold Temperature - Edge-Core ECS4810-12M Layer 2 Management Manual

| Interface Commands
C 27
HAPTER
Transceiver Threshold Configuration
transceiver-
threshold
temperature
C U
OMMAND SAGE
◆ The threshold value is the power ratio in decibels (dB) of the measured
power referenced to one milliwatt (mW).
Refer to the Command Usage section under the
◆
current command for more information on configuring transceiver
thresholds.
Trap messages enabled by the
◆
to any management station configured by the
command.
E
XAMPLE
The following example sets alarm thresholds for the signal power received
at port 1.
Console(config)interface ethernet 1/1
Console(config-if)#transceiver-threshold rx-power low-alarm -21
Console(config-if)#transceiver-threshold rx-power high-alarm -3
Console#
This command sets thresholds for the transceiver temperature which can
be used to trigger an alarm or warning message. Use the no form to
restore the default settings.
S
YNTAX
transceiver-threshold temperature {high-alarm | high-warning
| low-alarm | low-warning} threshold-value
no transceiver-threshold temperature
high-alarm – Sets the high temperature threshold for an alarm
message.
high-warning – Sets the high temperature threshold for a warning
message.
low-alarm – Sets the low temperature threshold for an alarm
message.
low-warning – Sets the low temperature threshold for a warning
message.
threshold-value – The threshold of the transceiver temperature.
(Range: -20000 - 20000 in units of 0.01 Celsius)
D S
EFAULT ETTING
°
High Alarm: 75.00 C
°
HIgh Warning: 70.00 C
°
Low Alarm: -123.00 C
°
Low Warning: 0.00 C
– 970 –
transceiver-threshold
transceiver-monitor command are sent
snmp-server host