Access-List Ip - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| Access Control Lists

access-list ip

This command adds an IP access list and enters configuration mode for

standard or extended IPv4 ACLs. Use the no form to remove the specified

[no] access-list ip {standard | extended} acl-name

standard – Specifies an ACL that filters packets based on the

source IP address.

extended – Specifies an ACL that filters packets based on the

source or destination IP address, and other more specific criteria.

acl-name – Name of the ACL. (Maximum length: 32 characters, no

spaces or other special characters)

Global Configuration

When you create a new ACL or enter configuration mode for an existing

ACL, use the permit or deny command to add new rules to the bottom

of the list.

To remove a rule, use the no permit or no deny command followed by

the exact text of a previously configured rule.

An ACL can contain up to 64 rules.

Console(config)#access-list ip standard david

Console(config-std-acl)#

permit, deny (927)

ip access-group (930)

show ip access-list (931)

Table of Contents