Raps-Def-Mac; Raps-Without-Vc - Edge-Core ECS4810-12M Layer 2 Management Manual

| ERPS Commands
C 35
HAPTER

raps-def-mac

raps-without-vc

E
XAMPLE
Console(config-erps)#propagate-tc
Console(config-erps)#
This command sets the switch's MAC address to be used as the node
identifier in R-APS messages. Use the no form to use the node identifier
specified in the G8032 standards.
S
YNTAX
[no] raps-def-mac
D S
EFAULT ETTING
Enabled
C M
OMMAND ODE
ERPS Configuration
C U
OMMAND SAGE
When ring nodes running ERPSv1 and ERPSv2 co-exist on the same
◆
ring, the Ring ID of each ring node must be configured as "1".
If this command is disabled, the following strings are used as the node
◆
identifier:
ERPSv1: 01-19-A7-00-00-01
■
ERPSv2: 01-19-A7-00-00-[Ring ID]
■
E
XAMPLE
Console(config-erps)#raps-def-mac
Console(config-erps)#
This command terminates the R-APS channel at the primary ring to sub-
ring interconnection nodes. Use the no form to restore the default setting.
S
YNTAX
[no] raps-without-vc
D S
EFAULT ETTING
R-APS with Virtual Channel
C M
OMMAND ODE
ERPS Configuration
– 1082 –